8016 Rugby St, Philadelphia, PA 19150

Description

One-floor living on one of the widest lots on the block. This stone-front rancher in Northwest Philadelphia sits on roughly 7,600 square feet of level ground with an attached garage, a long private driveway, and a rear patio deep enough for a full outdoor setup under mature shade trees. Homes with this much yard and this much parking rarely come available in the 19150.

Inside, the main level flows the way ranchers should: a tiled entry opens to an oversized living area with an archway into the dining space, and a second archway leading back to the bedroom wing. The layout is open, bright, and free of steps, with every principal room on a single floor. The eat-in kitchen runs the length of the rear of the house with wood cabinetry, gas cooking, dishwasher, generous counter space, and room for a full table plus a pantry closet.

Three bedrooms sit down the hall, including a primary with its own private full bath and an additional full hall bath serving the other two. Both baths are original to the home and in serviceable condition, with tile surrounds and tub/shower combinations. Closets throughout, plus a dedicated laundry and utility area with the washer, dryer, and gas hot water heater.

The full basement adds real square footage beyond what the tax record shows: a large finished lower-level room with an outside exit to the patio, plus unfinished storage and mechanical space. Use it as a family room, a home office, a gym, or in-law potential with a separate entrance already in place.

This home has been lovingly held by the same owner for years and is being offered in its current condition. It is clean, structurally sound, and ready for a new owner to bring cosmetic updates and build instant equity, or move right in and update over time. Gas heat, central air units in place, replacement windows in select rooms.

Convenient to Stenton Avenue, Cheltenham Avenue, regional rail, and major routes toward Center City and the suburbs. Showings begin at go-live. Schedule through ShowingTime.